R-Tech I-CUT100P Guía de instalación descargar pdf (Pagina 7)

7

1- Once the linkage rod has been cut

to the proper length assemble the

linkage rod with heat shrink tubing

and the rubber end.

2- Slide the heat shrink tubing over the

rubber end as far as it will go.

3- Heat the shrink tubing with a heat gun (hair

dryer or small torch will work).

Begin by heating the rubber end rst. The

heat shrink is lined with adhesive and will

stick to the rubber when heat is applied.

4- Continue shrinking the tube to the rod until

secured. Be sure not to overheat the tubing

causing it to pull from the rubber end.

5

-

Once both sides of the linkage have been

nished secure the linkage to the sensor

and suspension.

69 Camaro Front 58-64 Impala Front

Triangulated 4-Link Rear

Rear Trailing Arm

65-70 Mustang Rear C-10 Truck Rear

Ride Height Sensors

Assembly of the LevelPRO Sensor Link Rods

Sensor Mounting Examples

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios