R-Tech I-CUT100P Guía de instalación descargar pdf (Pagina 3)

MOUNT THE MAIN UNIT:

1- Mount the base at to the vehicle surface (do not bend the base)

2- Secure the base with self tapping screws or bolts.

3 - Secure the cover to the airpod base using the supplied screws.

CONNECT AIR LINES:

1 - Airline cuts must be straight and clean - use a razor blade or tubing

cutter. (part # - cut1000)

2 - All ttings are DOT approved, reusable, push-to-connect style. Firmly

push the airline into the tting to attach. To release the airline push the

collar on the tting back towards the tting and pull the airline out.

3 - All of our airlines are DOT approved so they are very strong. Secure the

airline with zip ties, keep them away from any sharp edges and when

passing through a hole in the frame use a grommet.

4 - Keep away from intense heat including muers and exhaust manifolds.

CONNECT POWER HARNESS:

1 - Connect the red power wire directly to the battery.

Use included fuse within 18” of battery.

2 - Connect the yellow ignition wire to switched 12v.

3 - Connect the black wire to chassis ground.

CONNECT LEVELPRO SENSORS

if equipped:

See LevelPRO section for more information

on installing and calibrating height sensors.

CONNECT DISPLAY / CONTROLS:

See control programming and additional

features section for more information on using

the control panel.

POWER  RED

SWITCHED YELLOW

GROUND  BLACK

Be sure to use included fuse

holder in the battery feed

wire as close to the battery

as possible.

CAUTION: Use 10 gauge wire or larger

to extend red power feed if needed

Installing an AirPod

Remove the negative battery cable before beginning installation.

STOP

AirPod Part #: APOD4000L APOD4000e3 APOD4100L APOD4100e3

1 2 3 4 5 6 7 8 ... 11 12

Sin comentarios

R-Tech I-CUT100P Guía de instalación Pagina 3